Optional - set the search domain for the cluster IPv4 address of the NTP server/s for the cluster IPv4 address of the subnet gateway for the data nodes Name of the node operating as the license server (management node).
Click the Edit button in the System tab.In the EXAoperation interface, Select Configuration > Network.You should be logged into the EXAoperation interface as an admin user. You can use the EXAoperation user interface ( Configuration > Network) to configure these settings. You can also add routes and additional networks if you make use of them.Ĭonfiguring the cluster network access include configuring the following settings: You can assign network settings for the cluster, such as the public network address, default gateway, NTP servers, and other variables. Various other trademarks are held by their respective owners.After you Configure Access Management, you can configure the cluster network through the EXAoperation user interface.
WatchGuard and the WatchGuard logo are registered trademarks or trademarks of WatchGuard Technologies in the United States and other countries. For example, if the first FireCluster has 5 interfaces, you must set the Cluster ID of the second FireCluster at least 5 higher than the Cluster ID for the first FireCluster.įor example, if the second FireCluster has the Cluster ID set to 56, the virtual MAC addresses are:įor more information about VRRP, see RFC 3768.
If you add a second FireCluster to the same subnet, you must make sure to set the Cluster ID to a number that is different enough from the Cluster ID of the first FireCluster to avoid a virtual MAC address conflict. The sixth octet of the MAC address is set to a value that is the hexadecimal equivalent of the interface number plus the Cluster ID.įor example, for a FireCluster with the Cluster ID set to 50, the virtual MAC addresses are: VRRP virtual MAC addresses start with 00:00:5E:00:01. The virtual MAC addresses for interfaces on an active/passive FireCluster are Virtual Router Redundancy Protocol (VRRP) virtual MAC addresses. How the Virtual MAC Address is Calculated You must reboot the Firebox after you change the Cluster ID. If you configure more than one active/passive FireCluster on the same subnet, it is important to know how to set the Cluster ID to avoid a possible virtual MAC address conflict. Active/Passive Cluster ID and the Virtual MAC AddressĪn active/passive FireCluster uses a virtual MAC (VMAC) address, calculated based on the Cluster ID and the interface numbers.
0 kommentar(er)
